BBK series explosion-proof transformer distribution box welding knowledge

 There are welding steps in the manufacturing process of distribution box, which is also a very important step to pay attention to.

Explosion-proof power distribution box manufacturer to make the process of distribution box, is the need to pay attention to it for welding, if welding method is not correct, then brings the certain effect to use in the future will be, when we are in the process of welding, it requires connection shall be solid, weld should be uniform, bright and clean, no welding, welding wear etc. Phenomenon, in addition to this is above the bolt, at the time of connection should be smooth, outlet and inlet line of reserved hole or knock off hole should have corresponding seal attachment, after the completion of the outlet and inlet line of the assembly can guarantee reaches 3 containment requirements.

The above problems are the problems that the explosion-proof distribution box manufacturer should pay attention to in the process of welding. Only in this way can it be better used. I hope the above explanation will be helpful to everyone.